SHA-3 Hardware Implementations

1 Important Information

This page summarizes key properties of reported hardware implementations of the SHA-3 candidates. This is work in progress. The implementations are categorized into FPGA and standard-cell ASIC implementations.

Note that the diversity of implementation scope, target technologies, and synthesis tools makes direct comparisions between different hardware implementation difficult. The more of these parameters agree, the more reasonable the comparison becomes.

The target technology should be as similar as possible. For FPGA implementation, it is desirable to compare implementations on the same target device (or at least on devices of the same FPGA family). For standard-cell ASIC implementation, at least the minimal gate length of the process (e.g., 0.13 µm) should agree. More ideally, the implementations use the same standard-cell library (which implies the use of the same process technology).

In order to facilitate the comparision of hardware modules with different implementation scopes, we classify them into three categories:

• Fully autonomous
• Using external memory
• Core functionality

For suggestions regarding the structure of this site, let us know at sha3zoo-hardware@iaik.tugraz.at

1.1 Fully Autonomous Implementation

Such hardware implementations include the complete functionality of a SHA-3 candidate (or a specific version thereof). That means the input message can be loaded piecewise into the hardware module and it delivers the message digest as output. All hash calculations happen exclusively within the hardware module. If integrated in a system, the achievable throughput of a fully autonomous implementation depends on the speed of the hardware module itself and the speed of the (system dependent) data interface delivering the input message.

1.2 Implementation with External Memory

These implementations use external memory to hold intermediate values during the hashing of a message. The implemented hardware itself normally consists of the core logic functionality of the hash function, some registers for short-lived temporary values, and possible a memory controller for access to the external memory. Such implementations can load the input message either over a dedicated interface (similar to a fully autonomous implementation) or from the external memory. In order to reach the maximal throughput of the hardware module, the external memory must be sufficiently fast.

1.3 Implementation of Core Functionality

Such implementations comprise only important parts of the hash function (e.g., the compression function), which normally allows to get a first-order estimate of the performance figures of full implementations.

2 High-Speed Implementations (FPGA)

Important note: The size and functionality of slices varies between FPGA families. A direct comparision of the slice count of implementations on different FPGA families is therefore problematic.

Hash Function Name	Reference	Impl. Scope	Impl. Details	Technology	Size	Throughput	Clock Frequency
BLAKE-32	Submission document	Core functionality	Compression function with 8 G function units	Xilinx Virtex 5	3091 slices	1724 Mbit/s	37.0 MHz
BLAKE-32	Submission document	Core functionality	Compression function with 8 G function units	Xilinx Virtex 4	3087 slices	2235 Mbit/s	48.0 MHz
BLAKE-32	Submission document	Core functionality	Compression function with 8 G function units	Xilinx Virtex-II Pro	1694 slices	3103 Mbit/s	67.0 MHz
BLAKE-64	Submission document	Core functionality	Compression function with 8 G function units	Xilinx Virtex 5	11122 slices	1177 Mbit/s	17.0 MHz
BLAKE-64	Submission document	Core functionality	Compression function with 8 G function units	Xilinx Virtex 4	11483 slices	1707 Mbit/s	25.0 MHz
BLAKE-64	Submission document	Core functionality	Compression function with 8 G function units	Xilinx Virtex-II Pro	4329 slices	2389 Mbit/s	35.0 MHz
CHI-224/256	Submission document	Fully autonomous	Iterative implementation	Xilinx Virtex 2	1582 slices	3200 Mbit/s	126.0 MHz
Grøstl-224/256	Submission document	Fully autonomous	P & Q permutation in parallel	Xilinx Spartan 3	6582 slices	4439 Mbit/s	86.7 MHz
Grøstl-224/256	Submission document	Fully autonomous	P & Q permutation in parallel	Xilinx Virtex 5	1722 slices	10276 Mbit/s	200.7 MHz
Grøstl-384/512	Submission document	Fully autonomous	P & Q permutation in parallel	Xilinx Spartan 3	20233 slices	5901 Mbit/s	80.7 MHz
Grøstl-384/512	Submission document	Fully autonomous	P & Q permutation in parallel	Xilinx Virtex 5	5419 slices	15395 Mbit/s	210.5 MHz
MD6	Submission document	Core functionality	Compression function with 16 parallel steps	Xilinx Virtex-II Pro	5313 slices	1232 Mbit/s	150.3 MHz
MD6	Submission document	Core functionality	Compression function with 32 parallel steps	Xilinx Virtex-II Pro	7529 slices	1894 Mbit/s	141.6 MHz
Skein 256	Men Long	Core functionality	UBI component	Xilinx Virtex 5	1001 slices	408.7 Mbit/s	114.9 MHz

3 High-Speed Implementations (ASIC)

Hash Function Name	Reference	Impl. Scope	Implementation Details	Technology	Size	Throughput	Clock Frequency
AURORA-224/256	Submission document	Fully autonomous	One round of one MSM and one CPM in parallel with 1 cycle latency (Type-H1), table-lookup S-box	0.13 µm	35.02 kGates	10352 Mbit/s	363.9 MHz
AURORA-384/512	Submission document	Fully autonomous	One round of one MSM and two CPMs in parallel with 1 cycle latency (Type-H1), table-lookup S-box	0.13 µm	56.75 kGates	9132 Mbit/s	361.2 MHz
BLAKE-32	Submission document	Core functionality	Compression function with 8 G function units	UMC 0.18 µm	58.30 kGates	5295 Mbit/s	114 MHz
BLAKE-32	Submission document	Core functionality	Compression function with 4 G function units	UMC 0.18 µm	41.31 kGates	4153 Mbit/s	170 MHz
BLAKE-64	Submission document	Core functionality	Compression function with 8 G function units	UMC 0.18 µm	132.47 kGates	5910 Mbit/s	87 MHz
BLAKE-64	Submission document	Core functionality	Compression function with 4 G function units	UMC 0.18 µm	82.73 kGates	4810 Mbit/s	136 MHz
CHI-224/256	Submission doucment	Fully autonomous	Iterative implementation	0.13 µm	101.46 kGates	4800 Mbit/s	188 MHz
Fugue-256	Submission document	Fully autonomous	Four SMIX transformations parallel	IBM 90 nm	109.85 kGates	13913 Mbit/s	869.5 MHz
Grøstl-224/256	Submission document	Fully autonomous	P & Q permutation in parallel (SUPER4_P)	UMC 0.18 µm	131 kGates	4379 Mbit/s	85.5 MHz
Grøstl-384/512	Submission document	Fully autonomous	P & Q permutation in parallel	UMC 0.18 µm	341 kGates	6225 Mbit/s	85.1 MHz
Keccak	Submission document	Fully autonomous	Core (round function, state register) & IO buffer	ST 0.13 µm	48 kGates	28400 Mbit/s	500 MHz
Keccak	Submission document	Fully autonomous	Core (round function, state register) only	ST 0.13 µm	40 kGates	15000 Mbit/s	500 MHz
LANE-224/256	Submission document	Fully autonomous	Six permutation blocks in parallel (two full AES engines each)	0.13 µm	243.49 kGates	14191 Mbit/s	305 MHz
LANE-384/512	Submission document	Fully autonomous	Six permutation blocks in parallel (four full AES engines each)	0.13 µm	466.19 kGates	20958 Mbit/s	286 MHz
Lesamnta-256	Submission document	Fully autonomous		90 nm	190.1 kGates	6026 Mbit/s	282.5 MHz
Lesamnta-512	Submission document	Fully autonomous		90 nm	393 kGates	9992 Mbit/s	234.2 MHz
Luffa-224/256	Supporting document	Fully autonomous	Three permutation blocks in parallel (64 S-boxes, 4 MixWord blocks each)	0.13 µm	26.85 kGates	12642 Mbit/s	444 MHz
Luffa-384	Supporting document	Fully autonomous	Four permutation blocks in parallel (64 S-boxes, 4 MixWord blocks each)	0.13 µm	34.99 kGates	12642 Mbit/s	444 MHz
Luffa-512	Supporting document	Fully autonomous	Five permutation blocks in parallel (64 S-boxes, 4 MixWord blocks each)	0.13 µm	44.16 kGates	12642 Mbit/s	444 MHz
MD6	Submission document	Core functionality	Compression function with 48 parallel steps	GPDSK 90 nm	145 kGates	N/A	200 MHz
MD6	Submission document	Using external memory	Compression function with 16 parallel steps & memory control logic	GPDSK 90 nm	105 kGates	N/A	200 MHz

4 Low-Area Implementations (ASIC)

Hash Function Name	Reference	Impl. Scope	Implementation Details	Technology	Size	Throughput	Clock Frequency
AURORA-224/256	Submission document	Fully autonomous	One round of one MSM or one CPM with 2 cycles latency (Type-H4)	0.13 µm	11.11 kGates	2179 Mbit/s	306.4 MHz
AURORA-384/512	Submission document	Fully autonomous	One round of one MSM or one CPM with 2 cycles latency (Type-H4)	0.13 µm	14.61 kGates	1191 Mbit/s	293.1 MHz
BLAKE-32	Submission document	Core functionality	Compression function with a single G function unit	UMC 0.18 µm	10.54 kGates	253 Mbit/s	40 MHz
BLAKE-32	Submission document	Core functionality	Compression function with a half G function unit	UMC 0.18 µm	9.89 kGates	127 Mbit/s	40 MHz
BLAKE-64	Submission document	Core functionality	Compression function with a single G function unit	UMC 0.18 µm	20.61 kGates	181 Mbit/s	20 MHz
BLAKE-64	Submission document	Core functionality	Compression function with a half G function unit	UMC 0.18 µm	19.46 kGates	91 Mbit/s	20 MHz
CHI-224/256	Submission document	Fully autonomous	Iterative implementation	0.13 µm	62.99 kGates	968 Mbit/s	38 MHz
Fugue-256	Submission document	Fully autonomous	One SMIX transformation (SUPER1_L)	IBM 90 nm	59.22 kGates	2000 Mbit/s	500 MHz
Keccak	Submission document	Using external memory	Small core using system memory	ST 0.13 µm	6 kGates	26 Mbit/s(*)	100 MHz
LANE-224/256	Submission document	Fully autonomous	One permutation block (one S-box and MixColumns block)	0.13 µm	16.46 kGates	23.3 Mbit/s	100 MHz
Lesamnta-256	Submission document	Fully autonomous		90 nm	20.7 kGates	336.9 Mbit/s	169.8 MHz
Lesamnta-512	Submission document	Fully autonomous		90 nm	44.3 kGates	571.9 Mbit/s	144.1 MHz
Luffa-224/256	Supporting document	Fully autonomous	One permutation block (One S-box, one MixWord block)	0.13 µm	10.16 kGates	28.7 Mbit/s	100 MHz

(*) Estimation for 64-bit memory interface based on published performance figures: (1024 bits/permutation) * (100 * 10^6 cycles/s) / (3870 cycles/permutation) = 26.46 * 10^6 bits/s

5 Call for contributions

Implementers (both submitters and non-submitters): You have results that complement this site? Let us know at sha3zoo-hardware@iaik.tugraz.at